General Note:
- It is always preferable to have a rear brace,
as it adds strength and rigidity to the frame and is
never in the flight path of the ball.
- If possible a rear
fold unit is chosen because the stored position is usually
out of the playing area of other events.
Model 1312 - Compak-fold Rear-braced
--Popular!--
Allows the face of the backboard to be close to a rear obstruction and
still fold backwards with a rear supporting brace. Has the smallest
ceiling footprint of any folding backstop. Our most popular series.
Add to Spec Builder
Model 1345 - Rear-fold Rear-braced
Standard rear fold unit used when there is sufficient room behind the face of
the backboard. Has a standard size ceiling footprint.
Add to Spec Builder
Model 1325 - Forward-fold Front-braced
Forward fold used when there is very limited distance from the face of the
backboard to a rear obstruction. Has a front brace.
Has a standard size ceiling footprint.
Add to Spec Builder
Model 1335 - Forward-fold Rear-braced
Used when there is a short distance from the face of the backboard to a rear
obstruction. Has the preferred rear supporting brace, but folds forward.
Has a large size ceiling footprint.
Add to Spec Builder
Model 1370 - Side-fold Rear or Front-braced
When an obstruction prevents the use of a standard rear or forward-fold
backstop a side fold unit is necessary. The nature of a Side-fold does not
allow the backboard to fold compactly against the ceiling.
Has a standard size ceiling footprint. Note the full width of the
backboard is exposed below the ceiling line.
Add to Spec Builder
Model 1355 - Forward-fold Front-braced Angled Mast
Used only to match the same appearance of existing angled mast frames in the
same gym. Has the largest ceiling footprint of the
entire line with a front brace.
Add to Spec Builder
Model 1400 - Stationary Wall-braced
Used when folding the backstop is not required and the distance from the
face of the backboard to the wall is 14'-0 or less (see 1500).
Add to Spec Builder
Model 1500 - Stationary Ceiling-braced
Used when a folding backstop is not required and the distance to the wall
to the rear is over 14'-0. Also used when matching the same appearance
of folding units in the same gym. Manufactured with a rear or front brace.
Has a standard size ceiling footprint.
Add to Spec Builder