Height Adjusters

September 19, 2017

The Manual Adjust-A-Goal Height Adjuster and the Electric Adjust-A-Goal Height Adjuster allows people of all ages to play basketball. The ADP height adjusters are able to give younger players the ability to compete at the height that is fair and fun for them by allowing the backboard to be adjusted anywhere between 8 feet and 10 feet. There is a goal indicator on the unit for accurate adjustment. All of the height adjusters feature a direct goal attachment that can transfer any stress and load the goal from the backstop’s structure, this is unique because it doesn’t depend on the backboard for support.

The Manual Adjust-A-Goal Height Adjuster features the unique spring activated manual locking mechanism that is designed to lock the threaded rod into place, which will eliminate any drifting of the backboard height. It includes the crank handle which makes for easy raising and lowering.

The vertical tubing allows the slide tubing to move freely without binding. The horizontal structure has two, 2 inch by 4 inch by 1/8 inch thick steel L braces; they are located at each end. There is a 3.5 inch by ¾ inch by 1/8 inch thick steel c-channel that is used as a direct goal attachment that will transfer loads from the backboard to the surrounding framework. The screw rod will be hardened and have a 5/8 inch diameter stub acme thread design. The height is adjusted by hand with a removable crank. The height adjustment label is located inside the slide channel and can be viewed from the back of the unit.

The Electric Adjust-A-Goal Height Adjuster is electronically operated to adjust the height of a backboard between 8 feet and 10 feet. It will require on of the three combinations for operation

            *Model 1158 Hardwire Kit

            *Model 1156 Remote control kit and Model 1198 Remote Control Transmitter

            *Model 1159 Power wand and Model 1157 Power wand wiring kit

The vertical tubing will allow for the slide tubing to move freely without binding. Horizontal structures are two, 2 inch by 4 inch by 1/8 inch thick steel L braces located at each end. A 3.5 inch by ¾ inch by 1/8 inch think steel c-channel is used as a direct goal attachment that can transfer loads from backboard to surrounds framework. The electric actuator provides a smooth, reversible linear motion for loads up to 600 pounds and travels 24 inches.

Both the Manual Adjust-A-Goal Height Adjuster and the Electric Adjust-A-Goal Height Adjuster come with a one year factory warranty that protects against defects in the material or the factory workmanship. The warranty does not cover any losses or damages that may be caused from improper installation, using the equipment for any purpose other than which it was intended for, unauthorized alterations or modifications to the equipment, or abuse or misuse of the equipment. If a defect if discovered in the materials or workmanship, is it important that you immediately contact ADP in writing. You must include your proof of purchase, the purchase date and the installation date. ADP will repair or replace the defective equipment as long as it is within the parameters that were previously stated. There will be no cost to the consumer to repair or replace the item, but the consumer will be responsible for the shipping and installation costs. The warranty states, “In no event shall ADP be liable for any incidental or consequential damages relating to, arising out of or in connection with the use or performance of the equipment, including and without limitation, any labor and/or other installation expenses incurred in connection with the replacement of the defective equipment warranted hereunder, or any other indirect damages with respect to loss of revenue or profits.

The Manual to Electric Height Adjuster Conversion Kit is able to convert your manual height adjuster to be electronically operated. The conversion can be done on location.


Subscribe